Thinking about adding a skylight? The biggest concern is always leaks. Here's why ours don't leak: we build a structural curb between the rafters, wrap it in ice-and-water shield, install step flashing on all four sides, and re-shingle around the unit with proper overlap. Then we verify the seal from inside the attic. Doss Roofing & Maintenance — leak-free skylight installation in Doss.
We install deck-mounted skylights and curb-mounted skylights. Deck-mounted units sit flush against the roof deck and work best for shingle roofs on standard pitch. Curb-mounted units sit on a raised frame and work on flat or low-slope roofs. Both types get the same flashing treatment: ice-and-water shield, step flashing, counter-flashing, and sealant at every transition.
Our Skylight Installation Process
Site Assessment
Our estimator visits your Doss home, inspects the attic framing, and recommends skylight size, type, and placement. We show you product options — fixed, vented, tubular — and provide a detailed written estimate.
Roof Opening & Framing
We cut the roof deck opening through the sheathing and shingles, then frame a structural curb between the rafters with doubled lumber. Headers distribute the load around the opening. The curb provides a solid, level base for the skylight unit.
Flashing & Waterproofing
Full flashing system: ice-and-water shield base layer, step flashing and counter-flashing on all four sides, woven into the existing shingle field. Water flows over the flashing and onto the shingles below — never behind them.
Final Seal & Trim
Skylight unit set into the curb and flange sealed to the roof deck. Shingles re-laid around the unit with proper overlap. Inside, rigid insulation installed around the light shaft to prevent condensation. Interior trim finished. Watertight verified from the attic.
What Doss Customers Say
"After getting several quotes, these guys stood out with their honesty and knowledge. No pressure, just straightforward advice and excellent workmanship."
"Responded fast and got the job done right the first time. Crew was polite, professional, and cleaned up everything. Would absolutely hire again."
"Our neighbors recommended them and now we understand why. Meticulous attention to detail and they treated our home like it was their own."
Why Choose Doss Roofing & Maintenance for Skylight Installation?
Insulated Light Shafts
Every skylight installation includes rigid foam insulation around the light shaft. Uninsulated shafts cause condensation and energy loss. We insulate, vapor-seal, and trim the interior for a finished look.
Structural Curb Framing
We frame a proper structural curb between your rafters with doubled headers. No flimsy brackets or foam shims. The curb carries the skylight load and provides a solid base for the flashing system.
Code Compliant
Every skylight installation meets TX building code for structural framing, energy performance, and egress requirements. Permits pulled when required.
Roofer-Installed, Not Handyman
Doss Roofing & Maintenance is a roofing contractor, not a general handyman. Skylights are roof penetrations — they require roofing expertise, proper flashing materials, and waterproofing knowledge. That's what we do every day.